![]() ![]() ![]() Insert the interior assembly into the exterior sleeve oriented as per the photo. Note the bottom holes of the exterior sleeve which are closest to the end of the sleeve must be oriented to the front of the interior assembly.ġ2. Install the four rear panel screws loosely. #INSTALL FREENAS ON IOMEGA STORCENTER IX2 INSTALL# Tighten the rear panel screws.Īlignment of the rear panel and the red on/off switch is critical. As the rear panel screws are tightened make certain that the red switch moves (clicks) freely in the hole in the rear panel. After the rear panel screws are tight finish tightening the bottom mounting screws. If it does not, loosen the rear panel screws and adjust its location to allow free movement of the switch. #INSTALL FREENAS ON IOMEGA STORCENTER IX2 FREE# Attach the StorCenter ix2 unit to the network and proceed with the RAID 1 rebuild.This version of the guide is obsolete. Look here for the 2021 version, which contains some necessary fixes since this was published. Jens Rommel contacted me and notified me of an issue with recent larger Linux boot files, also referred to in this post on the Arch Linux ARM forum. Systems might not be bootable when updated due to this issue. The remediation requires changes to the load addresses and entry points of the kernel and initramfs images. These changes have been incorporated in this guide. #INSTALL FREENAS ON IOMEGA STORCENTER IX2 FREE#. ![]() #INSTALL FREENAS ON IOMEGA STORCENTER IX2 INSTALL#. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |